quote:
Hapur, the RIGHT Welder can repair these breaks.
I thought that Hapur�s solution to the problem was a practical, straightforward way to get back into operation with minimal cost and effort. But that�s just from my perspective.
I had an old drill press table (cast iron) that somebody cracked. In the greater L.A. area (which is not small) I found the �go to� guy for that kind of repair and asked him to weld it (he did a lot of work for some of the aerospace and aerospace related companies). He said no, and recommended brazing which he did. He would not even touch machinery from Asia because of the inconsistency of the castings. FP
