|
Joined: Jul 2005
Posts: 1,813 Likes: 52
|
OP
Joined: Jul 2005
Posts: 1,813 Likes: 52 |
Hello Wotan and Dave
- You have a good point concerning the middle section; I agree, you have to drill there first, before you can do the saw through the hole and saw the middle section open. I didn’t see that. You are right here Wotan.
-There are also other drill holes that explain my vision: making a drill hole on the end, so you will not saw too far. All is on a very small scale! The maker first made scratch or pencil lines, a design of the initials on the gold plate. Look at the inside corners of the M ; in the corners you can see that the corners are a round ; in the drawing, on the end of the inside vertical lines of the M, the maker has marked a point for the drilling hole, first . The drilling hole was more or less, in the middle of the line, see here -----------------0 ( sawing line and hole) . The saw goes up and meets the drill hole in the middle .The result we see : the inside left line of the M ends a bit more to the left , the right line ends a bit to the right.
For me, both techniques are you used in this ring.
Benten
Last edited by benten; 02/24/2021 07:30 PM.
|
|
|
Forums42
Topics31,652
Posts328,709
Members7,501
|
Most Online5,900 Dec 19th, 2019
|
|
|
|