If you carefully hold the scabbard and hit the tip on a firm surface with padding on it to prevent ball damage, the weight will usually "seat" itself in the end of the scabbard. It 's a slightly delicate operation and you don't have to slam it down. Just a good firm tap or two should do it. But, there is no guarantee it will remain seated. The best solution is to carefully remove the side screws, so as not to "bugger" them and carefully put them aside so they don't get lost. You then try to remove the throat piece by pulling with your hand. If it is immovable, you will have to "drive" it out? This takes something like a price of wood placed under the lip of the throat and hit with palm of your hand or a few light taps from a hammer. You need to be vey careful not to damage the scabbard and upper fitting. Once the throat begins to move, you might have to tap either side to extract it. Be sure to remember which is the front because the screws will not necessarily align if you out the throat fitting in backwards. Remove the lower fitting screws. The lead weight should now slide out, if loose. Be sure you know which is the front for reassembly. Some merely apply adhesive to the the weight, reinsert it and ensure it is properly seated. The weight screw holes should align with those in the lower scabbard. For me, it is preferable to slightly distort the weight screw holes with a tool, so the screws will "catch " in them properly. You can test this before reinserting the weight. Reassembly is the reverse of disassembly. You might have to give the throat fitting a light tap or two to seat it. Usually, if you shake the scabbard up and down, holding vertically, you can hear and feel the weight rattling if it is loose.

Last edited by Grumpy; 03/02/2013 10:26 PM.