UBB.threads Forums Edged Weapons Army, Navy, and Luftwaffe Forum about Spitzer army dagger

hello,
from my collection is this dagger. an early Spitzer, where everything fits.
Fits the scabbard to the dagger, I'm not quite sure about this.
And have anyone a picture from a small Spitzer trademark for my side?
greetings oliver from Germany

Oli,

Your scabbard is a Holler product. This scabbard type with the single reverse screw was certainly used by Holler when they were still producing blades with a tapered tang and their briefly produced 2nd variant x guard (1936 ish). In my opinion it is not inconceivable that this config on a small producer is possible. The Pack fittings are certainly earlier as is the grip but being a small producer Spitzer may have held them in stock for a while. From what I can see the tone of the components match. Although one might expect a slant to have a scabbard with two dome headed side screws it is not by any means conclusive to me that the dagger did not leave their factory exactly as it is.

If I understood correctly I hope this answers your query.

Best regards