UBB.threads
Posted By: benten NSDAP badge RZM and GES. GESCH, - 09/29/2019 01:22 PM
What is your opniion about this badge; original or fake ?

Thanks in advance.
benten

Attached picture 1 (1) wc.jpg
Attached picture 1 (2) wc.jpg
Attached picture 1 (3) wc.jpg
Attached picture 1 (4) wc.jpg
Posted By: Militarynut Re: NSDAP badge RZM and GES. GESCH, - 09/30/2019 12:01 AM
hi benten
as far as your political button hole badge in my opinion its a good one marked very well hope you agree god bless andy militarynut
Posted By: benten Re: NSDAP badge RZM and GES. GESCH, - 09/30/2019 07:31 AM
Hi Andy,

Thank you for your reply .

benten
Posted By: J.R.Scott Re: NSDAP badge RZM and GES. GESCH, - 10/04/2019 09:58 PM
I agree it's good.
Posted By: benten Re: NSDAP badge RZM and GES. GESCH, - 10/05/2019 09:12 PM
Thanks for your reply Jamie.
It is not the area I'm familiar with. There are also opinions say that Ges.gesch. and RZM do not belong to together .
Was Ges. Gesch. replaced by the Nazis 1933 , in a factory number and RZM? I have no knowledge about this.
Posted By: Vern Re: NSDAP badge RZM and GES. GESCH, - 10/06/2019 12:38 AM
Ges. Gesch. is the German equivalent to "Patent" or "Registered". RZM was assigned by the NSDAP to show that the item was made to their specifications.
Posted By: benten Re: NSDAP badge RZM and GES. GESCH, - 10/06/2019 02:41 PM
Thanks for your info Vern .


Could it be a transitional badge, when the factory number still wasn't written on the badge ? Around 1933 ?
Posted By: Vern Re: NSDAP badge RZM and GES. GESCH, - 10/06/2019 04:01 PM
The requirement for RZM marks on Party material took effect in December 1934. A few items contracted for by the SS were maker marked and dated "34" or "35" but most items just had the RZM in a circle. The regulations for both the RZM mark and the manufacturer's code on Party material took effect in December 1935. At a guess, I would think that badge was made between December 1934 and the end of 1935.
Posted By: benten Re: NSDAP badge RZM and GES. GESCH, - 10/06/2019 04:26 PM
Vern, thank you again for this very good info !
© Your new forums