I saw this Sr Forestry dagger at the SOS, but waited until some time after the show to finally decide to try and get it.

I already had a very nice No 1713 pattern forestry and it had the 42 over shoulde Eickhorn trademark, so it was a tough call to replace it with this one.

Two reasons for the decision:

1 - this one is in slightly better condition. Actually, the only thing I can find fault with is that it has a couple of small dings in the back of the lower scabbard fitting.

2 - it has a distributor mark that I have never seen before, and unlike most of such marks, this is on the obvers and under the clamshell instead of on the spine.

So, here it is,

John

Obverse.JPG (39.88 KB, 358 downloads)
Reverse.JPG (39.42 KB, 359 downloads)
Obverse Hilt.JPG (41.31 KB, 358 downloads)
Reverse Hilt.JPG (38.99 KB, 359 downloads)
Obverse Etch.JPG (38.45 KB, 360 downloads)
Obverse Distributor.JPG (39.3 KB, 360 downloads)
Reverse Etch.JPG (40.4 KB, 359 downloads)
TM.JPG (40.88 KB, 360 downloads)

Always looking for Eickhorns and etched bayonets.